Kushan Carrier paper model
by Mobius
==========================

This is a fairly complicated model - if you've never done anything like this before, I'd suggest starting with something else like one of the Swarmers or the Taiidan station..


_____ = valley fold (points down into paper)

_ _ _ = mountain fold (points up from paper)

I think that's the opposite way origami books do it, but heck, this ain't origami.


SUGGESTED ORDER OF ASSEMBLY/CONNECTION

- bridge (the hardest part!)
- front
- main hangar
- forward top

- res. col. docks
- belly
- rear bottom
- side hangars
- engines

- connect those two subassemblies
- top - attach to sides first, then back, finally front

- For the antennae, cut them out and glue them to both sides of a piece of cardboard, posterboard, etc., then cut out of that and glue on the model.  (Superglue may help)


OTHER HINTS

- Cut out a section and CREASE everything BEFORE starting with the glue.

- Some of the smallest tabs don't need glue - the bigger tabs around them hold stuff in place well enough.

- It may help to enlarge each page to cover a full sheet of paper, though that may cause pixelation.


Happy folding!

